Low Profile Led Downlights

Features for low profile led downlights:

• ✔ INSTANT SAVINGS - Save over 85% energy on electricity of lighting.

• ✔ HIGH QUALITY - Made of aviation aluminium and ABS plastic, make fast heat dissipation become possible while being light and solid.

• ✔ DIMMABLE & CRI - LED Downlight has smooth dimming capabilities with modern LED dimmers. CRI95+, provides near-sunlight quality light for true color rendering and consistency inside your home, show natural color more vibrantly.

Specification for low profile led downlights:

Detail pictures of low profile led downlights:

How to remove the LED downlight?

Low Profile Led Downlights

How to remove the LED downlight? LED downlights are products developed on the basis of traditional downlights by applying new LED lighting sources. Energy saving, low carbon, long life, good color rendering, and fast response speed are all its advantages. So how to remove the LED downlight? Minghong Lighting is here to explain it for everyone, let's take a look.

LED downlights are very common in places such as aisles, living rooms, conference rooms, etc., and ceilings with suspended ceilings are more suitable. How to remove the LED downlight? The method is very simple. Downlight is a type of lighting fixture that is embedded in the ceiling and emits light. There is a spring buckle on each side, which can be taken off directly. Downlights generally have a screw base, which can be directly mounted on incandescent or energy-saving lamps.

1. Prepare the tools needed for replacement and maintenance of LED downlights. The common tools for replacing and repairing LED downlights are: electric tape, a set of LED downlights of the same model, pliers, and a small hand saw if necessary.

2. Turn off the power and buckle down the light slowly. Pay attention to the reed clip on the light. After you see it, press down and remove the light with your fingers. If you don’t pay attention to the reed clip, you will be injured by the reed clip if you pull the lamp head straight down. , So be careful to remove the old bad LED downlight.

3. Then first disassemble the connector, replace the lamp cap, the driver does not move, turn on the light switch, if the lamp does not light, it can be determined that the driver is faulty, replace the driver.

4. To turn off the light switch at this time, it is best to turn off the main power supply, then turn on the power supply line of the driver (shorten it directly), then remove the broken driver and tap the power input section of the new driver. , Peel the two lamp thread ends.

5. Wrap one of the driver power cords around one of the lamp power cords (the lighting power is not positive or negative) and wrap it with electrical tape, and connect the other one with the same connection method and wrap it with electrical tape.

6. It is about to be completed. Next, power up the experiment and turn on the switch and the light will light up. If it does not light up, repeat the above steps but instead of replacing the driver, you can directly replace the LED downlight.