Products
Led Replacement For F15t8 Fluorescent Tube
, 【LONG LASTING TUBE】 - Benwei shatterproof t8 LED tube lights have an outstanding life rating of 50,000+ hours! These LED tube can last 20+ years depending on use, eliminating maintenance costs and reducing relamp frequency.
【T8, T10 and T12 Compatible】Works from 100-277V AC. They are compatible with existing T8, T10, and T12 fluorescent fixtures, making LED conversion easier than ever.
Send Inquiry
Product Introduction
Shenzhen Benwei Lighting Technology Co., Ltd. is one of the best manufacturers and suppliers of led replacement for f15t8 fluorescent tube in China. Welcome to buy durable products for sale here and get pricelist from our factory. All customized products are with high quality and competitive price.
led replacement for f15t8 fluorescent tube
Product Features led replacement for f15t8 fluorescent tube:
High Output Tube 140-160Lm/W
2ft 60cm, 3ft 90cm, 4ft 120cm, 5ft 150cm, 6ft 180cm, 8ft 240cm
Energy Efficient ECO Green, No UV or IR radiation,Shatterproof
50,000+ hour lifetime
5-Year Warranty
G13 Bi Pin Base,Instant on,no any delay
Applications:
Garage and warehouse lighting
Kitchen lighting, office, workspace
Convenience stores and retailers
School buildings, classrooms and hallways
Supermarket, Shops, homes,storage room,ospitals ect.
More details led replacement for f15t8 fluorescent tube:
T8 LED tubes size:
Installation for round light tube:
Aluminum + partly transparent plastic tube (mainly PC tube, few people use acrylic):
Most of the LED fluorescent lamps on the market now use this structure, because the LED lamp beads basically emit light at 120º, so it is also a feasible method to use light-transmitting materials only on the light-transmitting side; and On the opaque side, aluminum is used to dissipate heat from the LED lamp beads. The light decay of this kind of LED fluorescent tube is usually much smaller (it depends on whether the LED lamp bead is made of SMD (SMD) or straw hat lamp; whether the lamp bead is attached with aluminum substrate or PCB board, etc.). Will analyze one by one).
Aluminum + PC mainly has the following situations:
One is 1/3 luminous surface, 2/3 aluminum or 1/2 luminous, 1/2 aluminum. This kind of LED fluorescent lamp has a problem. The light-emitting surface is too small, which causes the LED to emit light to be concentrated on the front. The latest Japanese safety regulations have made requirements for this aspect "within the range of 120 degrees." It is important to pay attention to the luminous flux not exceeding 70%. Its characteristic is that the light can fully reach the part exceeding 120 degrees. The luminaire has the use of a reflector to obtain the desired light orientation. Such luminaires are very It is difficult to use a light tube that is only bright directly below the tube. In addition, if the light does not reach the surroundings of the tube, there will be a situation of "discomfort because the wall is dark but bright directly below." In order to prevent this, it is necessary to To meet this condition, you can visit: "Specific requirements and parameter analysis of Japanese LED fluorescent lamp specifications" for details.
One is a large-luminous-surface LED fluorescent lamp, that is, more than half of the luminous surface, like a T8-LED fluorescent tube made of green fluorescent light, the luminous surface is as high as 2/3. The light-emitting angle is as high as 240º, and most of the wall can be illuminated without shadows. The thickness of the power supply of this LED fluorescent lamp is only 7mm high.
Hot Tags: led replacement for f15t8 fluorescent tube, China, suppliers, manufacturers, factory, buy, price, best, cheap, for sale, in stock, free sample
Send Inquiry
