Description of relevant regulations for the correct installation of LED street lights
In the process of installing LED street lights, the standard installation method is the prerequisite to ensure our correct use. The difference between LED street lamp manufacturers and conventional street lamps is that the LED light source adopts low-voltage DC power supply, and is a high-efficiency white light synthesized by GaN-based power blue LED and yellow. It has high efficiency, safety, energy saving, environmental protection, long life, fast response speed, and display. Unique advantages such as high color index can be widely used on roads. The outer cover can be made, the high temperature resistance can reach 135 degrees, and the low temperature resistance can reach -45 degrees. Low maintenance cost of LED street lights: Compared with traditional street lights, the maintenance cost of LED street lights is extremely low. After comparison, all input costs can be recovered in less than 6 years. The LED street lamp has an automatic control energy-saving device, which can achieve the greatest possible reduction in power and energy saving under the condition of meeting the lighting requirements of different periods. It can realize computer dimming, time period control, light control, temperature control, automatic inspection and other humanized functions. Below, we introduce to you the specifications that should be paid attention to in the correct installation of LED street lights.
First of all, the installation height, elevation angle and direction of the LED street lights on the same road (from the light source to the ground) should be the same. The size of the excavation of the foundation pit shall conform to the design specifications. The strength grade of foundation concrete shall not be lower than C20. The cable sheath in the foundation should pass through the center of the foundation and should exceed the foundation plane by 3050 mm. The water must be removed from the pit before pouring the reinforced concrete foundation. The metal parts used to install LED street lights, such as lamp posts, lamp arms, hoops, bolts and pressure plates, should be hot-dip galvanized. The anti-corrosion quality should comply with the relevant regulations of the current national standards.
The longitudinal centerline of the LED lamp installation should be the same as the longitudinal centerline of the lamp arm. The horizontal line of the luminaire should be parallel to the ground, and there should be no tilt after tightening. The LED lamp holder is firmly fixed, the adjustable lamp holder should be adjusted to the correct position according to the design, and the lamp holder wiring should comply with the regulations. LED lamp arm, lamp panel and lamp pole have no joints. The perforated orifice should be smooth and free of burrs. Insulating sleeves or bandages should be used. The length of the bandage should not be less than 200 mm. Fasten various nuts, add washers and spring washers. The nut shall not be less than two pitches after tightening.
The above is about the correct installation of LED street light specifications. If you have any questions, please call to consult. We will continue to update more related instructions. You can pay attention to our website for more information.
