Lighting is an important part of our life indispensable, in our homes and around the use of a variety of types of lamps and lanterns, induction footlights is one of them, in some outdoor or some families can see their figure, for some families with a yard or house area is relatively large when installed will consider the installation of induction footlights, then to install induction lights at home, these knowledge is you have to know. Let's learn about it.
Question1: Are induction floor lamps wired?
1, in fact, the sensor footlights are to be wired. At the beginning of the wiring, after reserving the location the footlights can be installed. Induction footlights do not need to be controlled by the switch, can be directly connected to the power supply, and then they will work automatically according to the environment and function. In general, setting aside a good zero wire and firewire can be, because it has the induction function, so it can achieve normal function without going through the switch.
2, when the human body is in the detection range of induction footlights walking, it detects human movement will automatically light up, and delayed for a period of time, and then extinguished. If the human body is detected again during the delay, the delay time will be recalculated. It should be noted that: after the induction floor lamp is connected to the power supply, it needs to go through a 50-second warm-up time before it can enter the normal working state.
Question2: The characteristics and functions of the induction floor lamp
1, based on infrared technology for automatic control, at night or when the light is dark when someone enters the infrared induction range, special sensors detect changes in the infrared spectrum of the human body, and the switch automatically turns on the load and turns on the LED bulb; when the person leaves, the light is automatically turned off after a delay of 30s, the light comes on, the light goes off when the person leaves, friendly and convenient, safe and energy-saving.
2, with over-zero detection function; extend the life of the load. Application of photosensitive light-sensitive control, automatic light measurement, daytime or when the light is strong does not sense to turn on the light.
3, in the daytime or when the surrounding light is strong, the installation of induction fast off, because of the default state of the induction switch, and the light is not lit (at night or when there is not enough light, someone close to inductively light the light), you can also test the induction switch by covering the probe of the induction switch tightly with your hand so that the light will be lit.
4, in the same place, the use of more than 2 footlights, if the distance is relatively close, or under the influence of other light sources of irradiation, does not necessarily start at the same time.
5, most of the choice of footlights a choice of auxiliary lighting tools, so the light emitted by this lamp is relatively soft, at night since the role of lighting and not harsh, and this lamp is a kind of radiation-free lighting, low failure rate, easy maintenance, low-temperature rise, long life, low power consumption, for a small number of activities at night. Such as going to the bathroom, at night if the ordinary light will affect others to rest, the footlights will not. General hospital wards are equipped. Also suitable for squares, gardens, street lighting, etc.
