Knowledge

Home/Knowledge/Details

LED breeding light does not light up

LED breeding light does not light up

The led breeding light does not light up, but it lights up slightly after it is powered on. What's going on?

The following is a professional led breeding lamp engineer from Shandong Suiguang Intelligent Technology Co., Ltd. to teach you how to solve it. This phenomenon indicates that the LED constant current drive power supply has been damaged, and there is only a weak induced current, and the main reason for the damage of the LED constant current drive power supply is very likely. It is because the electrolytic capacitor has dried up and failed, or the built-in MOS tube of the built-in constant current driver chip is too small and overheated and damaged.

led tri-proof light

Principle of LED light

There is a DP950 XB in the circuit, which is a constant current driver chip. There is a built-in MOS tube inside the chip. The built-in MOS tube of the constant current drive power supply of ordinary LED lights on the market is usually about 12 ohms. The heat is serious. If the ambient temperature is high and the 24-hour working system is used, the temperature accumulates to a certain level, which exceeds the thermal limit temperature of the chip silicon, causing avalanche breakdown and the circuit is disconnected. Only a weak induced current flows through the lamp bead. At this time, we The only thing I can see is that the LED light is off and the power is on.

How to prevent the led breeding light from turning off and light up slightly after power on? To buy a high-quality led breeding light, you only need to put forward the following requirements when purchasing. If the manufacturer or distributor can meet the requirements, the purchased light will not be too bad:

1. High temperature resistant lamp beads;

2. Aluminum substrate;

3. The light efficiency is above 140lm/W;

4. The lifespan of the LED drive electrolytic capacitor is required to be 10,000 hours;

5. The whole lamp is required to be guaranteed for five years;

6. Do not use all plastic lamps, and aluminum heat dissipation should be used for heat dissipation.