Knowledge

Home/Knowledge/Details

LED Garden Light Module

LED special switching power supply. Power supply can only moistureproof, can not waterproof, so the external power supply must do a good waterproof measures. Switching power supply according to the characteristics of the LED module to adjust the output voltage, please use the process should not be free to rotate the voltage adjustment button. LED modules are low voltage input, requiring power supply installed in the LED Light-emitting module within 10 meters.LED Garden Light


Led there are positive and negative points, the installation of attention to the power port wiring must be positive and negative, if positive and negative, the module will not glow, will not damage the LED module, as long as the exchange can be normal. LED module using Low-voltage input, so must not be directly connected to the power supply 220V, otherwise it will cause the whole module burned. Keep in mind! When installing the LED module, it is required to use double-sided adhesive or woodworking glue, so that the module card groove and blister backplane firmly pasted. In the use of double-sided adhesive, must be added to play glass glue, otherwise in the outdoor sunlight for a long time, will cause the module to fall off.LED Garden Light


Blister word or box installed in the module, as far as possible to use a three-point, four-line, as far as possible in connection with the whole Word or box to form a loop, or a plurality of loops, that is, with the red and black power cord to each stroke at the end of the module by positive and negative The Power Port outlet module in series group should not exceed 50 groups, or the end module will be due to voltage attenuation, resulting in reduced brightness. Although the formation of loops can avoid the occurrence of attenuation, but also should not connect too many modules.LED Garden Light


No water treatment LED module, installed in the Font or box, should prevent rainwater into the font or box. Module spacing can be adjusted according to the brightness requirements, each square metre of cloth points best control between the $number group. When the power cord is plugged into the enclosure, it must first be connected to the corresponding four or three sets of modules through a four or three-point line. Power cord into the box should be a larger knot, in case it is outside the full pull off.LED Garden Light


Single-line length is 12~m, 15~m two kinds, according to the actual use. The upturned connecting line (including the unused connecting thread) is fixed on the blister base to prevent shading. installation, not push, squeeze, pressure module on the device, so as not to cause damage to the device, affect the overall effect. In order to prevent the connection line from falling easily from the line seat, the line seat is designed with barb, if the insertion is inconvenient, should exit reinsert. It is necessary to confirm that the cable is tight, otherwise it will cause the future to fall off.LED Garden Light