LED light bar controller function introduction
Function 1. Set the color
(as in the original setting). Additional: Each color button has 5 layers of different colors, which are programmable. So instead of 15 we have 15x5 = 75 colors. The red, green and blue components of the color can be set using the knobs, which are then saved in one of the 75 color slots.
Function 2. Set the flickering effect
Sets color effects for flickering and smooth fading (same as original). Extra: 5 different layers for simultaneous sparkle and fade effects. Each effect layer can store 15 programmable colors selected from 75 pre-saved colors. Adjust brightness/effect speed (like the original). Bonus: In addition to adjusting with the remote buttons, the knob can also be used to get precise brightness/speed without jumping forward or backward in chunks. Has an additional music effect that changes the brightness of the current color/effect based on the loudness of the music. There are 5 layers available, of which the color when muted can be changed (usually it is best to change to black).
Function 3. Ability to save settings
5 layers of programmable settings. Each layer will store values for brightness, effect speed, and audio sensitivity, which can be recalled and applied instantly. The values of the first layer are applied whenever the system is freshly booted. Clap to start the function. The clap command is a 3-beat combo so the LED doesn't accidentally light up with loud music. Master reset function. Set all saved colors, effects and settings to default. When powered on, fades from black to the previously selected color. Every time the power is reconnected, the colors saved in row 3, column 2, layer 3 of the remote are selected by default.

Function 4. Circuit Description
In order to pick up and process the audio signal from an electret microphone, it must first be amplified. A very concise explanation of how amplifiers work can be found in this Instruction by amandaghassaei. I'm using a slightly modified version of her circuit that uses a single power supply instead of dual power supplies. After trial and error, the capacitor and resistor values were chosen. The output is centered about 2.5V through the R2-R3 voltage divider and fed into the AVR's analog input pins.
Function 5. Manufacture the PCB
Time to make the PCB. Download Eagle files, print, heat transfer, etch and drill. If you don't know how to make a PCB, there are a lot of good instructables here to get you started. Excited, I forgot to transfer the screen print photo with toner. I only realized my mistake after I had all the components of the amp soldered and tested the amp section to my satisfaction. Enjoy silkscreen half coverage.
Benwei Lighting is an LED Tube, LED flood light, LED Panel Light, LED High Bay, LED manufacturer with 12 years of experience. If you want to purchase a high-quality LED flood light or have a more in-depth understanding of the application of LED flood lights, please contact send us inquiry, our web:
https://www.benweilight.com/.




