Led explosion-proof lamps are mainly high-power LED beads and packaged integrated chips, which are customized in combination with the requirements of the external structure of the lamps and the applicable places. However, the selection of LED explosion-proof lamps needs caution, especially the selection of power and lamps. The power of lamps and the size of LED lamp housings are closely combined, because the temperature of LED lamps is high, High power lamps naturally need a larger shell to achieve good heat dissipation.
Summary of characteristics of LED explosion-proof lamp:
1. LED light source is adopted, with low power, long service life, high efficiency and energy saving.
2. Advanced and reasonable circuit design, high electrical efficiency, high reliability, energy saving and maintenance free.
3. The optimized structural design, light alloy shell, dust-proof, waterproof and impact resistant ensure that the lamps are maintenance free and avoid unsafe factors in maintenance.
4. The LED explosion-proof lamp adopts high-tech surface spraying treatment technology, which is corrosion-resistant, reliable and durable, and can be reliably used in harsh environments
Precautions for installation and maintenance of LED explosion-proof lamp:
1. Regularly eliminate dust and dirt on the shell of explosion-proof lamps to improve the lighting efficiency and heat dissipation performance of lamps. The cleaning method can be water spraying (the mark on the lamp is above Yin) or wiping with wet cloth according to the protective capacity of the lamp shell. When spraying water for cleaning, the power supply shall be cut off. It is forbidden to wipe the plastic shell (transparent part) of the lamp with dry cloth to prevent static electricity.
2. Check whether the transparent parts have been impacted by foreign matters, and whether the protective net is loose, desoldered, corroded, etc. If any, it should be stopped and repaired and replaced in time.
3. If the light source is damaged, turn off the lamp in time and notify the replacement, so as to prevent the ballast and other electrical components from being in an abnormal state for a long time due to the failure of the light source to start.
4. If there is water in the lamp cavity of lamps used in humid environment, it should be removed in time, and the sealing parts should be replaced to ensure the protective performance of the housing.
5. When opening the lamp shade, disconnect the power supply and open the cover according to the requirements of the warning board.
6. After opening the cover, check whether the flameproof joint surface is intact, whether the rubber seal is hard or sticky, whether the insulation layer of the wire is green and carbonized, and whether the insulation and electrical components are deformed and scorched. If these problems are found, they should be repaired and replaced in time.
7. Before closing the cover, wipe the light return and transparent parts of the lamp with a wet cloth (not too wet) to improve the light efficiency of the lamp. Apply a thin layer of 204-1 replacement type antirust oil on the flameproof joint surface, and pay attention to whether the sealing ring plays a sealing role in the original position when closing the cover.
8. The sealed part of the lamp shall not be disassembled and opened frequently. Patented road sealing technology; It is more in line with the new national explosion-proof technology.
Application field of LED explosion-proof lamp: it is suitable for emergency evacuation and lighting in case of power failure in flammable and explosive dangerous places and environments such as oil mining, chemical industry, gas stations and coal mines.




