If you don't know these three points, don't buy LED street lights at will!
Street lights need to be lit every day, and the lighting time is relatively long. If the quality is not too hard, not only the people are not satisfied, but also the management and maintenance of street lights is also a big task, so the lighting rate of street lights is one of the key indicators. . Then at the beginning of the purchase of street lamps, the following key links should be grasped.
1. Procurement
When purchasing, the first is the light decay test report, which is a very important link. When bidding, each company will provide light attenuation test reports of different units, some provide their own self-test, and some third-party tests. Although the test reports here are good, the actual light attenuation is very different. The reason Everyone knows it, so how can we discern the real product with our eyes?
The test report is first and foremost a designated agency of the Semiconductor Alliance. For example, Beijing Electric Light Source Quality Supervision and Inspection Center, Shanghai Electric Light Source Quality Supervision and Inspection Center, and the Thirteenth Institute of Semiconductors, etc., the light decay of the test reports from these units is credible. The street lamps used for road lighting have high power and generate large amounts of heat. The detection of light decay shows two problems: the light decay is qualified, and the power supply is passed. If a street light can't pass the test in the laboratory, can the quality be guaranteed when it is still on the road?
Second, the structure of the street light
After passing the pass of the street light attenuation test, the structure is a big problem. This problem has received little attention in the industry, and it is also one of the main reasons for the large light decay when street lamps are actually used.
As we all know, the area of smog in the country is so large, it not only harms people's body, but also causes the degradation of street lights. Especially in the northern region, there is a lot of dust and haze. Covered with dust, its cooling effect is greatly reduced. This is also one of the main culprits that LED street lights are not known by everyone.
According to this situation, the lighting design must be transparent from top to bottom. The heat dissipation area is doubled, because no street lamp management department will clean the radiator on time. In long-term use, it can only be washed by rain. After the area is enlarged, it will leave enough to reduce the effective heat dissipation area due to pollution.
3. Light source part
There is a wooden barrel effect in the decline of street lights, and it is not enough to have a short board. The light decay has plagued everyone for so many years. The problem here is that you can solve the light decay by making the radiator of the lamp well. No, everyone started to discuss it in the past. Using a low-power chip shell-type package, but a high-power chip will not work. It is said that the heat cannot be dissipated due to the high power of the chip. This is not the case. The COB package has more concentrated heat, and the heat conduction problem can be completely solved by using an aluminum bracket or a copper bracket.
However, it is more difficult to control the light decay. The reason is that a good heat sink may not solve the problem of light decay of the light source. There is a big misunderstanding in the light source packaging. The silica gel of the COB light source is too thick. The light-emitting surface dissipates heat, which is why the light decay of the COB light source is not well controlled.
