Correctly carry out the daily maintenance of lighting
Correct installation is a prerequisite
The correct installation of lighting is the premise of prolonging the service life of lighting. If installed incorrectly, the lighting can be easily broken, and sometimes even explode, which is very dangerous. At home, bathroom and kitchen lighting should be installed with special care.
The lamp in the bathroom must be equipped with a moisture-proof lampshade, otherwise the service life of the lamp will be greatly shortened; the kitchen lamp should pay special attention to preventing oil fume, because the accumulation of grease will affect the illumination of the lamp; and the light-colored lampshade has better light transmittance, but It is easy to stick to ash, so it is necessary to wipe it diligently so as not to affect the penetration of light; generally speaking, do not let the lighting of the kitchen and bathroom be placed in a position where water vapor condenses easily, so as to avoid bursting.
Home soft lighting
Aging lamps should be replaced early
The two ends of the lamp tube that have been used for a long time will turn red or have dark shadows. At this time, it should be replaced in time, in order to prevent unsafe factors such as ballast burnout. Generally speaking, when purchasing lighting, the effective time of the lamp bulb will be marked, and the aging lamps and bulbs will be replaced regularly, which is very helpful for the overall lighting maintenance.
The cleaning method should be correct
After the lamp has been used for a period of time, a thick layer of ash will be deposited on it, which affects our vision and needs to be cleaned regularly. During the cleaning process, be careful not to change the structure of the lighting, nor to replace the parts of the lighting casually. After the cleaning and maintenance, the lighting should be installed as it is, and do not miss or wrongly install the lighting components.
Generally, the lighting is wiped with a dry cloth, and attention should be paid to prevent moisture intrusion. If the lighting is non-metallic, it can be wiped with a damp cloth to avoid dust accumulation and hinder the lighting effect.
Frequent switching on and off lights
Do not switch on and off frequently when the lighting is in use, because when the lighting is started frequently, the current through the filament is greater than the current during normal operation, causing the temperature of the filament to rise sharply and accelerate its sublimation, which will greatly reduce its service life. Therefore, it is necessary to minimize the switching of lighting. frequency.
