How to install led street light fixtures
1. LED street lamp manufacturers are a solid-state cold light source, which has the characteristics of environmental protection, no pollution, low power consumption, high light efficiency, and long life. Therefore, LED street lamps will become a good choice for energy-saving transformation of road lighting. LED street light is a kind of high-efficiency solid-state light source formed by semiconductor PN junction that can emit light with weak electric energy. Under a certain forward bias voltage and injection current, the holes injected into the P zone and the electrons injected into the N zone are in After being diffused to the active area, photons are emitted through radiation recombination, which directly converts electrical energy into light energy. Fixing of various components: fix the solar panel on the solar panel bracket, fix the lamp head on the cantilever arm, fix the bracket and the cantilever arm on the main pole, and pass the connecting wire through the control box (battery box). LED street light is a kind of high-efficiency solid-state light source formed by semiconductor PN junction that can emit light with weak electric energy. Under a certain forward bias voltage and injection current, the holes injected into the P zone and the electrons injected into the N zone are in After being diffused to the active area, photons are emitted through radiation recombination, which directly converts electrical energy into light energy.
2. Before the light pole is raised and lowered, first check whether the fasteners of each part are firm, whether the lamp holder is installed correctly, and whether the light source is working normally. Whether it works normally in a simple debugging system; loosen the solar panel cable on the controller and work with the light source; connect the solar panel cable and turn off the light; at the same time carefully observe the changes of the indicators on the controller, Everything was normal before the lift.
When hoisting the main light pole, you should pay attention to safety measures; the screws are absolutely fastened, such as the installation of sunrise angle deviation, etc., you need to adjust the direction of the sun upward to make it completely facing south.
4. Put the battery into the battery box, and connect the cable to the controller according to the technical requirements; first connect the battery, then the load, and then the solar panel; when wiring, please pay attention to the wiring and terminals marked on the controller. The wrong connection is not allowed, the positive pole and the negative pole cannot collide, and cannot be reversed; otherwise the controller will be damaged.
5. Debug the system to see if it is working normally; loosen the solar panel cable on the controller and light it up; connect the solar panel cable at the same time, and the light goes out; then carefully observe the change of the indicator on the controller; everything is normal RMAL, the control box is OK seal.
Benwei Solar Street Lights Outdoor Lamp
Product Features:
>LED light, solar panel, lithium battery and controller,all in one compact design.
>No wiring,100% solar powered ,easy to install and ship.
>Built-in infrared sensor,can adjust the light output automatically(time control + light sensor control+ motion sensor control).
>Rust-proof, dustproof and waterproof IP65.
>5 years warranty.
