How to maintain and waterproof solar LED street lights?
During the use of solar LED street lights, it is not finished after installation and use. Normal maintenance work is required to make the LED street lights play the product performance. How to carry out the waterproofing work during maintenance work, we will organize the relevant instructions below. Solar LED street lamp manufacturers differ from conventional street lamps in that the LED light source adopts low-voltage DC power supply and high-efficiency white light synthesized by GaN-based power blue LED and yellow. It has high efficiency, safety, energy saving, environmental protection, long life and fast response. , Unique advantages such as high color rendering index, can be widely used in roads. The outer cover can be made, the high temperature resistance can reach 135 degrees, and the low temperature resistance can reach -45 degrees. LED street lamp manufacturers ED street lamps have much higher light color rendering than high-pressure sodium lamps. The color rendering index of high-pressure sodium lamps is only about 23, while the color rendering index of LED street lamps is more than 75. From the perspective of visual psychology, it can reach the same brightness and the illuminance of LED street lamps is average. It can be reduced by more than 20% compared with high-pressure sodium lamps.
How to maintain solar LED street lights?
Take solar panels as an example. In normal maintenance, check the azimuth angle of the solar panels, whether it is branches, leaves or other objects directly obstructed. Whether it is other objects in the shadow area, whether there are cracks, ashes, or dirty light surfaces. Whether the monomer is cracked and whether the connecting line is flat, all are within the detection range. In the LED street lamp use system, the maintenance of the battery is the most difficult, because the service life of the normal battery is 2≤3 years, the charging and discharging of the battery should be checked regularly during its life cycle, and whether the electrodes or wiring are corroded or corroded should be observed at any time. Bad contact. This is the main maintenance work for LEDs.
How to use solar LED street lights for waterproofing?
The sealing of the lamp cap must be passed, and the waterproof treatment of the lamp cap can ensure the service life of the street lamp. Therefore, the choice of the shell of the street lamp is very important. When choosing, you must pay attention to whether the style is waterproof. When installing the controller, it is generally placed inside the road, so as to better avoid wind and sun. It is necessary to have a certain degree of waterproof performance. For the installation of the battery, the battery is buried under the ground, about 40 cm, so as to avoid flooding. Finally, the solar LED street light head should be tested to see if the street light is normally lit, if it is lit, it can be used normally, if not, it needs to be replaced.
Basically, the above related instructions are related instructions on how to maintain solar LED street lights and waterproof work. If you have any questions, you are welcome to inquire, and Benwei will continue to update related instructions for you.
