Sharing related points of LED high bay light installation
LED high bay lights are accepted by the majority of users due to their high reflectivity and high power factor. However, the installation of good lamps and lanterns should be standardized, so as to highlight its advantages. The following editor will tell you about the installation of LED high bay lamps.
1. Determine the installation height of the LED high bay light. According to the lighting environment, the height of the general lamp should be above 5 meters, and the wire should not be close to the shell of the high bay lamp, because the environment will change the reflection efficiency of the lamp. If conditions require it to be less than 3 meters during installation, protective measures must be taken to avoid vehicle contact.
2. LED high bay light wiring. Usually the main line to the lamp is connected by a flat hard copper wire, which is evenly connected to the three-phase line according to the requirements of load balance.
3. LED high bay light waterproof and low temperature treatment. Generally, high bay lamps with waterproof function are selected, and waterproof transformers are selected. The chip package of the lamp is wrapped with heat-resistant thermal insulation material. It is required not only to be waterproof, but also to avoid damage to the lamp due to low temperature.
That's all about the installation of LED high bay lights, I hope it will be helpful to everyone.
