The flood light is not prone to damage during use
The flood light is actually a kind of spotlight, so its illumination angle can be adjusted, so its use is more flexible, and the general floodlight will have an angle adjustment scale plate, so that it can be in accordance with the markings of the scale plate It is better to make adjustments. Compared with other lighting fixtures, the size of the floodlight is very small and exquisite, so it can adapt to the needs of a wider range of installation sites, and it is not prone to damage during use, and it will not be caused by too long use. Heat, naturally its service life is relatively long. led flood light
Flood lights are mainly used in large-area operation sites, building outlines, stadiums, overpasses, monuments, parks, and flower beds. Almost all large-area lighting fixtures used outdoors can be regarded as LED floodlights. The angle of the projecting light beam is wide or narrow, and the range of variation is between 0° and 180°. Among them, the narrow beam is called a searchlight. The cast light has bright colors, good monochromaticity, soft light, low power, long life, and light-emitting time of up to 50,000 hours. Moreover, the LED flood light has a small body, is easy to hide or install, is not easy to be damaged, has no heat radiation, is beneficial to protect the illuminated object, and has a wide range of applications.
The lighting effect of LED flood light is very good, we can observe from its lighting effect that the light is very soft, it will not produce any irritation to the human eye, and it can protect the eyesight. In fact, the effect of light is more important. Especially for lighting places, if the effect presented is very dazzling, then such a product must be unqualified. In addition, the operating voltage of this type of product is relatively small. led flood light order
Benwei Flood light manufacturers
LED floodlights basically use 1W high-power LEDs (each LED element will have a high-efficiency lens made of PMMA, and its main function is to secondarily distribute the light emitted by the LED, that is, secondary optics), and there are A few companies have chosen 3W or higher power LEDs because of the good heat dissipation technology. It is suitable for lighting in large-scale occasions and buildings.
The floodlights of floodlight manufacturers are generally high-power lamps. When the floodlight starts to work, it will start to heat up, and the air inside the lamp will expand. At this time, it builds pressure on the rubber ring, and the air ran out; then after the light went out, the air pressure inside was reduced, so the air outside was pressed in.
