1. During installation, check whether the basic data listed on the product label meets the actual conditions of use;
2. When installing, introduce the cable or conductor into the terminal through the lead-in device, and then clamp the sealing joint with a metal compression nut or an explosion-proof cable (press the rubber sealing ring to the cable seal with the anti-cable pull-out device, pay attention to the outer diameter of the cable and The matching of the lead-in device used (see the cable lead-in device mark or the table above for the outer diameter of the cable, so as to avoid the phenomenon that the small cable wears the large sealing ring, so as not to squeeze the seal tightly and affect the explosion-proof performance). If the steel pipe is used to pass through the conductor, the explosion-proof isolation seal box
3. Before using the product, check whether the installation of each component is correct, whether the wiring is accurate, whether the sealing strip is in good condition, etc.
4. The internal and external grounding of the product must be reliably grounded;
5. It is strictly forbidden to open the cover by electricity to ensure the safety of operators and the site;
6. During installation and maintenance, the power supply of the preamp should be cut off before opening the cover. After opening the cover, check whether the parts are in good condition, and replace the damaged parts in time;
7. During installation and maintenance, the sealing strip should be completely attached to the groove, the flameproof joint surface should be evenly coated with 204-1 anti-rust oil, and the fastening screws should be tightened;
8. If the rubber sealing ring and gasket are found to be aged, cracked or lost during the maintenance process, the rubber sealing ring and gasket of the same material and hardness specified in the technical regulations should be replaced immediately (or the same material and gasket specified in the technical regulations should be changed by the manufacturer. Rubber sealing rings and gaskets with hardness (or contact the manufacturer to order), so as not to affect the explosion-proof and protective performance of the product;
9. When repairing the product, pay attention to the selection of materials when replacing metal parts to ensure the corrosion resistance of the product;
10. In order to ensure the normal operation of the product, the user must conduct regular inspections in accordance with the following provisions;
1) During external inspection and cleaning, if it is found that the paint layer of the metal casing and parts is peeled off or corroded and rusted, it should be polished and wiped with gauze, and then painted with anti-rust paint;
2) Check whether the electrical performance of the product is good;
3) It is recommended that users maintain it once every six months and once a year.
Benwei Lighting is an LED Tube, LED flood light, LED Panel Light, LED High Bay, LED manufacturer with 12 years of experience. If you want to purchase a high-quality LED flood light or have a more in-depth understanding of the application of LED flood lights, please contact send us inquiry, our web: https://www.benweilight.com/.




