What are the advantages of LED all-plastic tubes?
1. The aluminum substrate does not need to be pasted with silica gel, it wears the same as the original aluminum tube-simpler operation,
2. The thermal conductivity is 5 times that of the original PC-heat dissipation guarantee point,
3. A lamp tube is about 70 grams lighter than the original aluminum-plastic tube and 100 grams lighter than the glass tube—the freight is lower,
4. Don’t fall off, keep stepping on-less waste,
5. The special plug has a buckle, no glue, and no screws-higher efficiency,
6. The plug buckle locks the aluminum substrate at the same time-the light bar is easy to fix.
1. Light weight-1.2M18W bare tube is 148g±3g, which is about more than the original aluminum-plastic tube
A reduction of 70 grams is about 100 grams less than the glass tube.
2. Large light-emitting angle-the light-emitting angle of the whole series is greater than 300 degrees, and the original aluminum-plastic tube can only
180-210 degrees.
3. High luminous efficiency-the overall lighting efficiency of the domestic chip is about 105 LM/W, that is, 18W
Above 1900LM, it can be achieved with imported chips or lamp beads
130LM/W.
4. Less heat-the temperature rise on the back is 18-20 degrees, the temperature rise on the front is 5-6 degrees; using high power
The method of reducing the current of the lamp beads (5730 88) fundamentally reduces the
Heat.
5. Wide input——85--265V/50-60HZ input, adapt to global voltage.
6. High pressure resistance-all plastic structure, the whole lamp has passed AC6000V test; absolutely safe.
7. High power factor—The power factor is higher than 0.97, which exceeds Energy Star requirements.
8. No stroboscopic-there is no stroboscopic phenomenon when shooting at 0.5M from the tube.
