What are the tips for debugging the led street light system?
The debugging of street lights in the process of installation is very important, so what tips can be applied to the system debugging of LED street lights .
Before the led street light is installed and hoisted, the battery should be tested again to see if the lamp can be lit to avoid being discovered after the hoisting is completed, which increases the cost of installation and commissioning. What are the skills in this process?
1. Time control function setting. According to the daily lighting time designed in the design plan, set the time control point according to the instructions of the controller. The lighting time every night should not be higher than the design value, and can only be equal to or less than the design value.
2. Light control function simulation. If it is during the daytime, you can use opaque objects to completely shield the light-facing surface of the solar cell array after wiring (or remove the battery assembly wiring on the controller), according to the delay time mentioned in the controller manual (usually 5min), See if the lamp can be turned on automatically after the corresponding time has passed. If it can be lit, it means that the light control function is normal, and if it can not be lit, it means the light control function is invalid, and the controller setting needs to be rechecked.
I will introduce you to the relevant instructions about what tips can be used in the process of entering and debugging LED street lights. If you have any questions, you are welcome to inquire, and we will continue to update more relevant content for you.
Benwei Solar Street Lights Outdoor Lamp
Product Features:
>LED light, solar panel, lithium battery and controller,all in one compact design.
>No wiring,100% solar powered ,easy to install and ship.
>Built-in infrared sensor, can adjust the light output automatically(time control + light sensor control+ motion sensor control).
>Rust-proof, dustproof and waterproof IP65.
>5 years warranty.
