LED panel light is an ultra-thin, energy-saving, environmentally-friendly and safe LED lighting fixture. It has the advantages of good color consistency, multiple color temperatures, high brightness, long life, low energy consumption, and environmental protection. How do we install the LED panel light after purchasing the LED panel light?
There are three ways to install the LED panel light:
The first installation method: fixed bracket
First, drill a few screw holes in the ceiling, then install the LED panel light slide-in ceiling frame on the ceiling, and fix it on three sides. Then slide the panel light into the fixed slide-in mounting frame, and then screw on the fourth side to fix the frame. Convenient, simple and time-saving.
The second installation method steel wire suspension type
First, fix the hanging wire installation parts on the ceiling, and lock the screws (the hanging wire has been installed before leaving the factory.) The hanging wire is vertically down, and the components are hung on the back of the LED panel light. Installation is easy and trouble-free. Consumers must pay attention to inquiries to understand whether a clear hanging component is a manufacturer's standard accessory or an option.
The third installation method is embedded
Install the sheet metal groove on the ceiling first, then fix a few outwardly protruding brackets on the back of the LED panel light, and then put the panel light in so that the bracket matches the sheet metal groove on the ceiling, and then it can be fixed on the ceiling. However, because the thickness of various ceilings is different, it is necessary to adjust the height between the lamp surface and the bracket, otherwise it will cause the phenomenon that the LED panel light is higher or lower than the ceiling surface after it is installed.
The above three installation methods should also pay attention to the following installation matters during the actual installation process:
1. Please make sure that the power has been cut off before installation;
2. Pay attention to waterproof, electric and shockproof;
3. The standard working voltage of the product should not exceed the working voltage range;
4. This product is for indoor use only;
5. Please read the imitation form carefully before installing the product.
