The difference between infrared sensor and radar led fluorescent tube
A.Benwei infrared LED fluorescent tube infrared induction LED smart fluorescent tube (people and vehicles enter the sensing area, the lamp is constant, the lamp enters the low-frequency voltage after a delay of 30 seconds and remains dim) Application scope: garage lighting renovation, factory lighting engineering renovation, school lighting Engineering renovation, hospital lighting engineering renovation, supermarket lighting engineering renovation, shopping mall lighting engineering renovation, banks and other places that require long hours of lighting every day; use infrared control chip to individually control each lighting LED intelligent fluorescent tube in the parking lot, when there is no vehicle in and out , All Langte smart LED fluorescent tubes are in a dimly bright state, and each smart LED fluorescent tube consumes 2W in dimly bright state, which not only meets the brightness requirements of security monitoring lighting, but also saves electricity to a large extent. When a vehicle enters and exits, the intelligent infrared dimming chip of the corresponding area is sensed to light up, the power is 9W, and the brightness reaches the brightness of 30W ordinary fluorescent lamps, which is convenient for car owners to stop. When the car or people are moving in the sensing area, the intelligent LED fluorescent tube is always Keep it always on. When the car or person leaves the sensing area for about 30 seconds (adjustable), the smart LED fluorescent lamp will automatically re-enter the dim state, with a power of 2W.
B.Benwei radar microwave induction The radar induction LED fluorescent lamp uses the principle of the Doppler effect, the radar intelligent automatic microwave LED induction controller, and intelligently detects the surrounding electromagnetic environment. The intelligent radar microwave sensor, like a radar, emits wireless microwaves. When an object moves into the microwave sensing range of the LED tube, it will interfere with the microwave signal. The sensor will light up when the signal is detected. When the object leaves or stays still for 30 seconds Then it enters the dimly lit standby state. The radar sensor LED tube does not require a lens, has a wide sensing angle, high sensitivity, and strong reliability. It is a high-tech energy-saving application product in the field of LED lighting and automatic control. It is composed of precision instruments. The operation of the LED microwave sensor It is very stable, as long as the wall thickness is less than 5 cm in the sensing range, it can be sensed by the partition wall, but the distance is slightly shortened. Especially the built-in radar microwave sensor makes the appearance of the LED tube more beautiful and beautiful. The standby brightness of the induction lamp can be selected according to the brightness and darkness of the surrounding environment. It automatically senses that the person or car is fully bright when the person or car comes. After the person or car leaves, it returns to the dim lighting state according to the set time. The brightness can be set to 30%. Generally, the underground garage needs to be slightly brightly illuminated, so that it does not appear gloomy and terrible, and it saves more than 90% of electricity than a 100% always-on lamp. The sensing light time and sensing distance can be adjusted automatically. Ultra-low lighting power consumption at rest, generally 2-5W, and can be adjusted according to the environment; when the human body or car moves and enters, it automatically senses full-load work, and Lante is generally 9W or 18W (0.6 or 1.2m lamps); full-load work Time 30 seconds-60 seconds adjustable according to the environment; sensing distance 1-9 meters; average daily power consumption 10W; radar switch sensing distance is farther, wide angle, no dead zone, can penetrate glass and thin wood, according to different power It penetrates walls of different thicknesses, and is not affected by environment, temperature, dust, etc. When users choose, they can choose according to their own use requirements.
