0.3m T8 LED tube light, T5 0.3m LED tube
Langte T8/T5 has a LED tube with relatively low power, only 3-4w, which is the smallest LED tube. This model is divided into T8 split type and integrated type, T5 integrated type, although the power is small, due to the relatively high luminous flux, it can also reach 300-400lm, which is higher than the brightness of ordinary LED bulbs. It is widely used in showcases, testing and other occasions, as described below.
1. Split T8 0.3m LED fluorescent lamp, actual length is 298mm, diameter 26mm, 2835 lamp beads 0.2w, aluminum substrate heat dissipation, number of lamp beads 24, single lumen value 22-24lm, CRI 80, color temperature 6000k , Using aluminum-plastic tube, because the lamp tube is relatively short, and the power is relatively small. Generally use non-isolated electricity
The source is better, but it can also be a small-volume isolated power supply. Integrated T80.3m led fluorescent lamp, length 300mm, width 30, height 40, built-in power supply, the led light board is the same as the split type, but the shell is different, the power mode is plug type, single-ended or double-ended power, equipped with installation card It is easy to install and can be installed in series.
2. One-piece T5 0.3m led tube. Because the T5led tube is too thin and its diameter is only 16mm, no manufacturer has made split T50.3m led tube, but if the customer needs it, the company can also do it. However, it is possible to use an external power supply. The power is small. One power supply is enough. It can even achieve a power supply with multiple LED tubes, which is what people often call one-to-two or one-to-three. Integrated T50. 3m led tube is relatively common, the power supply and aluminum substrate, the lamp beads can be the same as the T80.3m led tube, increasing the versatility, and even 220v, 12v, 24v led tube can be made, the volume size is, length 0.3 meters, 2.3cm wide and 3.2cm high. Of course, other styles and sizes are different. The method is more flexible. Langte also has an LED tube with a switch, that is, a wave switch is installed on the side of the T5 bracket, but for the high-voltage LED tube, insulation must be done. The low pressure is convenient.
