Do you know the installation steps of LED panel lights?
Do you know the installation steps of LED panel lights? The following editor will take you to see:
LED panel lights are not only high-brightness, but also the light source is made of imported ultra-high-brightness LEDs in series. Conventional per meter, the encrypted arrangement of 30LED/m or 60LED/m is the fundamental guarantee for the overall luminous effect and high brightness. In addition, it has a safe bottom voltage and low power consumption. Because its light source is LED, it can work normally even in the case of 24V, and its power consumption is 4.8W/). Longevity and durability, on the basis of LED technology, with a new structure, this lamp can achieve 100,000 hours of ultra-long service life and other advantages under any circumstances.
When the light strip is installed, it is generally placed in the light trough, and it can be straightened. It can be fixed with a thin rope or thin iron wire. If you need external or vertical installation, you need to purchase clips and tail plugs separately. The four-wire light strip has a total of four wires and three rows of lights. Each row of 1 meter 24 lights, 24*3=72. Because the power of each lamp bead is 0.05W, the power of the 72-bead lamp strip is: 72*0.05=3.6W.
Each light strip must be equipped with a special plug (plug with a transformer); when connecting, be sure to remove the transparent plastic cover, and then cover it after connecting the test light. Do not connect directly with a cover, it is easy to short-circuit! There is a "scissors" mark for each meter, which can only be cut when the mark is cut. Wrongly cut or cut off will lead to one meter of no light! Some may miss some when marking, It is best to carefully look at the position of the mark before cutting, and cut it according to the unconnected part in the middle. You can see it if you look closely.
The above is the knowledge of the installation steps of LED panel lights that Xiaobian shared with you today, I hope it can help you.
