The LED light source of explosion-proof led lamp has a long life; the battery maintains a stable brightness in the late stage of full charge and discharge; a heat dissipation device is installed on the lamp housing, which can eliminate the effective heat dissipation of the LED module and ensure the stability of use. It is suitable for coal mines, petroleum, Railway, flood control and other work lighting. Suitable for Zone 1, Zone 2 hazardous locations, IIA, IIB, IIC explosive gas environment. Suitable for zone 0, zone 21 hazardous locations, IA, IB, IC explosive gas environments. Through the unique light distribution design, the explosion-proof lighting can control the light type and luminous point of view of the LED light source to avoid light pollution and ineffective light utilization; the light is soft and no glare, which will not cause the eyes of the operators to be tired and improve work efficiency. The shell is made of lightweight aluminum alloy die-casting, and the exterior is treated with high-voltage electrostatic spray. There is a wiring cavity inside the lamp, and there are special wiring terminals. The user can directly enter the line during installation, and there is no need to set up a separate junction box, which is convenient for installation. Nowadays, many people think that as long as it is an explosion-proof lamp, it is the same as a general lighting lamp when installed, and it is enough to just connect it. This kind of thinking is wrong.
If the explosion-proof lighting device does not meet the requirements. Explosion-proof lamps and lanterns should meet the following requirements: Explosion-proof high bay lamps should be fully equipped, and non-explosion-proof parts should not be used to replace lamp accessories (metal, lampshade, junction box, etc.). The shells of lamps and switches should be intact, without damage, dents and grooves, without distortion of the metal mesh, without cracks in the lampshade, and the explosion-proof signs should be clear. The number of thread engagement between the lamp hanger and switch and the junction box shall not be less than 5 buttons. Thread processing should be lubricated and free of rust, and the threads should be coated with electrical compound grease or conductive anti-rust grease. Tighten the fastening bolts of lamps and switches to ensure that they are not loose, and the sealing gasket should also be intact. Because LED is a solid-state cold light source, it has the advantages of high electro-optical conversion efficiency, low heat generation, low power consumption, low operating voltage and long service life. Therefore, high-power white light LED is an explosion-proof lamp, especially a portable explosion-proof lamp. Very ambitious electric light source. Explosion-proof LED lighting fixtures should be complete, and non-explosion-proof parts cannot be used to replace lighting accessories (metal, lampshade, junction box, etc.). The shells of lamps and switches should be intact, without damage, dents and grooves, without distortion of the metal mesh, without cracks in the lampshade, and the explosion-proof signs should be clear.
The number of thread engagement between the lamp hanger and switch and the junction box shall not be less than 5 buttons. Thread processing should be lubricated and free of rust, and the threads should be coated with electrical compound grease or conductive anti-rust grease. Tighten the fastening bolts of lamps and switches to ensure that they are not loose, and the sealing gasket should also be intact. The installation orientation of the luminaire should be away from the release source, and not above or below the pressure relief openings and discharge openings of various pipes.
Benwei Lighting is an LED Tube, LED flood light, LED Panel Light, LED High Bay, LED manufacturer with 12 years of experience. If you want to purchase a high-quality LED flood light or have a more in-depth understanding of the application of LED flood lights, please contact send us inquiry， our web: https://www.benweilight.com/.
