The factors to judge LED high bay light products start from those points
With the continuous improvement of technology, more and more are imitated. Taking a lamp as an example, it can be seen that there are many similarities. The quality of LED high bay lights is also very different. The high bay light manufacturers will answer for you. There are many differences in the production environment and craftsmanship. Then we judge the quality from the following points when purchasing LED high bay lights:
1. Observe the whole: "The power factor of LED high bay lights": The low power factor indicates that the driving power and circuit design used are not good, which will greatly reduce the service life of the lamp, and the low power factor will make the life of the lamp no matter how good the lamp bead is. It won't be long.
2. my country's LED lighting safety standards have been promulgated, and products must meet the safety standards set by the country.
3. Look at the heat dissipation system of the LED high bay light design, the heat dissipation of the high bay light directly affects its quality and service life.
4. Look at the quality of the lamp beads: the quality of the lamp beads directly determines the quality of the high bay lamp, and the quality of the lamp beads is determined by the chip quality and packaging technology.
5. Look at the light effect: the same lamp bead power, the higher the light effect, the higher the brightness, the same lighting brightness, the lower the power consumption.
6. Look at the driving power used by the industrial and mining lamp, the service life of the power supply is much shorter than that of other parts of the lamp.
The life of the power supply affects the overall life of the lamp. The theoretical life of the lamp bead is between 50,000 and 100,000 hours, while the life of the power supply is between 20,000 and 30,000 hours. The design and material selection of the power supply will determine the service life of the power supply.
Precautions for the use of LED UFO High Bay factory lights:
1. For LED factory lights, check whether the power supply voltage is consistent with the rated voltage of the lamp.
2. The lamp should be installed and fixed with a hanging chain, and the installation surface should be flat and have sufficient mechanical strength.
3. There is a ground wire (yellow) and two power wires on the lamps of the LED factory lights.
4. Turn on the power and the light is on.
Factory lights are generally used in workshops, processing workshops, warehouses, large-scale machine tools, etc.
The deep illumination type and the super deep illumination type are used outside the tall and large factory buildings (above 6 meters), and the wide illumination type, uniform light distribution type, and illumination type can be used for general lighting (below 6 meters)
