How to install led downlight? How to repair led downlight?
LED downlight is one of the common lamps in life. It is more common to live in the aisle in the living room. I believe many people should have seen it. And this kind of lamp is suitable for the floor and does not take up extra space. , Then how to install the led downlight? How to repair led downlight? Let’s take a look at BENWEI LIGHTING.
led downlight
How to install led downlight?
1. Drilling
Most of the LED downlights are embedded installation, so drilling is the first step. We need to accurately measure the downlights embedded in the ceiling to determine the aperture size and installation location. After confirming these two requirements, you can start smashing.
2. Wiring
There are generally two wires in the downlight, namely the live wire and the neutral wire. During the excavation process, the live wire of the led downlight should be connected to the live wire in the original ceiling hole; the neutral wire should be connected to the neutral wire. Before starting the whole connection, make sure that the main switch in the house is closed to avoid electric shock accidents.
3. Wrap tape
Wrapping tape is a very important link, it is to prevent the occurrence of leakage. After the two wires are connected, they must be wrapped with insulating tape to prevent leakage. After wrapping the tape, turn on the power, check the power on, whether the contact is good, and so on.
4. Fixed adjustment
After the downlight is fixed, the specific angle and height can be adjusted. As long as the fixed spring is used, you can adjust it to a position you like. After reinforcement, you only need to open the lamp card, and you can directly install the bulb into the lamp holder.
led downlight
How to repair led downlight?
1. Prepare the tools required for replacement and maintenance of led downlights. Common tools for replacing and repairing led downlights are: electric tape, a set of LED downlights of the same model, pliers, and a small hand saw if necessary.
2. Turn off the power and buckle down the light slowly. Pay attention to the reed clip on the light. After you see it, press down and remove the light with your fingers. If you don’t pay attention to the reed clip, you will be injured by the reed clip if you pull the lamp head straight down. , So be careful to remove the old bad led downlight.
3. Then first disassemble the connector and replace the lamp head. The driver does not move. Turn on the light switch. If the lamp does not turn on, it can be determined that the driver is faulty. Replace the driver.
4. At this time, turn off the light switch (for safety), it is best to turn off the main power supply, and then unplug the power supply line of the driver (shortening directly is also possible), then remove the broken driver and turn on the new driver power supply. The input section is peeled, and the two lamp wires are peeled.
5. Wrap one of the driver power cords on one of the lamp power cords (the lighting power is not positive or negative) and wrap it with electrical tape, and connect the other one with electrical tape in the same way.
6. It's about to be completed. Next, power on the experiment, turn on the switch and the light will light up. If it does not light up, repeat the above steps but instead of replacing the driver, just replace the led downlight!
led downlight
Let me stop here for the explanation of the knowledge of how to install led downlights and how to repair led downlights. I believe you will know more about it after reading it. The content is for your reference only, and I hope it can be helpful to everyone. .
