How to install the ceiling light? Precautions for ceiling lamp installation
Ceiling lamps are a kind of lamps. As the name suggests, they are lamps that are attached to the top. These lamps are usually installed on the ceiling or ceiling. Because of the installation method, they are called ceiling lamps. How to install the ceiling lamps? What are the precautions for ceiling lamp installation? Next, BENWEI will explain it for everyone, let's take a look.
Ceiling light
How to install the ceiling light?
First, the installation tool
To install the ceiling light, we must first prepare the necessary installation tools, such as: impact drill, electrician's pliers, screwdriver, insulating tape, a small piece of wood, and a wooden ladder.
Second, choose a good location
The first thing to do when installing a ceiling light is to determine the position of the ceiling light. Linear incandescent or fluorescent lamps should be installed in the front part of the cabinet. In this way, part of the light emitted by the lamp will be directed to the rear baffle, and then reflected on the operating table, and then directed toward the center of the entire space.
Third, remove the ceiling lamp mask
Remove the ceiling lamp mask. After removing the mask, remove the lamp tube by the way. Under normal circumstances, the ceiling lamp mask has two fixing methods: rotation and buckle. Please pay attention when removing it to prevent it from being installed. When breaking the lamp.
Fourth, install the base
First, we pass the previously reserved wire through the wire hole of the base, use one hand to hold the base of the ceiling lamp and place it in the position to be installed, and then use a screwdriver to screw one of the screws into the empty place, being careful not to screw it It’s too dead, so that it can be moved when the position is not accurate. After checking, the position is correctly placed.
Fifth, connect the wires
After fixing the base, you can connect the power cord to the ceiling lamp socket. It should be noted that the two wires connected to the ceiling lamp power cord should be in good electrical contact, and they must be wrapped with black tape. Keep a certain distance.
Sixth, install the mask strap
Install the mask and pendant. After connecting the wires, you can try to power on. If everything is normal, you can turn off the power and install the ceiling lamp mask.
Ceiling light
Precautions for ceiling lamp installation:
1. When installing, be sure to turn off the power to maintain personal safety.
2. The two thread ends connected to the power supply of the ceiling lamp must be wrapped with black tape and kept at a certain distance to avoid short circuit and danger.
3. If the screw is used in the ceiling lamp, it is recommended to connect the phase wire to the terminal of the center contact and the neutral wire to the threaded terminal.
4. When installing ceiling lamps in masonry structures, pre-embedded bolts or expansion bolts must be used, and wooden wedges must not be used. It is also necessary to ensure that the ceiling material matches the load-bearing capacity of the ceiling lamp.
Ceiling light
The above is the introduction of how to install the ceiling lamp and the precautions for the installation of the ceiling lamp. I believe you should have more understanding after reading it. The content is for reference only, and I hope it can be helpful to you.
