Installation time: 5 minutes
5 Simple Steps:
1. Simply connect one end of the bent pipe to the main body unit and another end with the ‘Anchor ear B’ using M8x50 screw and M8x50 screw respectively.
2. Next is to secure the anchor ear B to its base with 4pcs M8x100 screws as shown in the diagram.
3. Secure the Anchor ear B to the Anchor ear A using 4pcs of M8x100 screws.
4. Place the lamp head onto the pole and secure with screws. Make sure that the LED source is vertically aligned with pole or set it at the desired direction.
5. At the bottom of the lamp is a switch for the microwave sensor. Press it once the installation is finished. The LED lamp will then light after 1 min delay and will turn off automatically when not needed.
