Installation method of LED high-power surface mounted downlight
There are many types of downlights, such as surface mounted downlights, concealed downlights, surface mounted downlights are divided into ceiling installation and hoisting downlights, this time I will tell you the installation method of LED surface mounted downlights!
1. Introduction of surface mounted downlight
The LED high-power surface mounted downlight produced by Benwei Lighting, based on the original low-power surface mounted downlight structure, further improves the light effect of the LED surface mounted downlight, the design power of the lamp, the illumination brightness and the uniformity, and the installation is simple and the lamp is more economical. cost. The LED surface mounted downlight uses a high-power single-chip light source, the high-power chip light source is uniformly geometrically arrayed on a high thermal conductivity substrate, and the encapsulated high light-transmitting and temperature-resistant silica gel is equipped with phosphors required by the design to ensure color temperature and color Drift meets the requirements. The entire LED light source module is proportioned at 150% higher than the design power.
The radiator of the lamp is extruded from 6063 aluminum alloy, and the inside of the lamp tube is provided with a heat-dissipating aluminum cup that can be screwed, which not only ensures the installation of the LED light source module, but also ensures that when matching different light source lenses, due to different For the problem of the difference in the height of the lens with different beam angles from the manufacturer, the height between the tempered glass and the light source module should be adjusted reasonably to achieve structural matching.
Chimney-shaped convection holes are provided on the upper and lower covers of the lamp to ensure that the heat of the light source and power supply can be quickly convec Reverse the whole column, so that the mounting bracket can be assembled at will without removing the upper cover of the lamp. The round holes and a pair of small holes set on the top can not only facilitate the installation of the boom, but also quickly install the rope. The safety rope can be installed. The weight of the lamp is 6 times, much higher than the 4 times the lifting weight required in the current standard.
Second, the installation method of surface mounted downlight
1. First, fix the top-mounted bottom piece with the lifting ring on the ceiling, just like the installation method of the chandelier, first stick the bottom piece to the top to trace the hole, then use an electric drill to drill the hole, and drive into the embedded part , And then pass the reserved power cord through the center of the bottom part to connect with the power cord of the iron pipe.
2. Rotate the lamp counterclockwise to separate it from the bottom, then connect the other end of the iron pipe power cord that just passed through the bottom to the lamp, and then rotate the lamp clockwise to fix it on the bottom.
3. Install the bulb, then turn on the power to test whether it can be used normally, and use an electric pen to test whether there is any leakage.
