Installation Requirements for Common Poultry Breeding Lights
Regarding the introduction of the installation requirements of poultry breeding lights, the following are the insights of Shandong Suiguang Intelligent Technology Co., Ltd.:
1. Lamps and accessories should be complete, and there should be no defects such as mechanical damage, deformation, paint peeling and lampshade cracking.
2. The bearing capacity of the fixtures on the wall and ceiling where the lamps are installed should match the weight of the lamps.
3. The chandelier should be equipped with a hanging box, and each hanging box can only be installed with one set of chandeliers. The surface of the chandelier must be well insulated, there should be no joints, and the cross-section of the wire should not be less than 0.4 square millimeters. The wiring in the hanging box should be prevented from Measures to prevent the lamp from falling under the force of the wire head. Lamps weighing more than 1 kg should be provided with a hanging chain. When the weight of the hanging lamp exceeds 3 kg, it should be fixed by pre-embedded hooks or bolts. The lamp wire of the hanging chain lamp should not be subjected to tension. , the light wire should be braided with the sling chain.
4. Ceiling lamps with incandescent lamps as light sources shall not be directly installed on combustible components; the bulbs shall not be close to the lampshade; when the distance between the bulb and the insulating table is less than 5 mm, heat insulation measures shall be taken between the bulb and the insulating table .The power of incandescent lamps must not exceed the maximum power allowed by the lamp.
5. When the fluorescent lamp is used as the light source, the ballast should be installed on the phase line. The lamp should be installed on the lamp to prevent the lamp foot from falling off the shell, and there should be a margin in the lamp box. The frame of the giant lamp should be parallel to the decorative line of the ceiling. The frame should be close to the ceiling surface.
6. The phase wire of the screw cap should be connected to the terminal of the central contact, the neutral wire should be connected to the terminal of the screw, and the insulating shell of the cap should be complete, free from damage and leakage.
7. The diameter of the hook for fixing the lantern should not be smaller than the hook of the lamp, and the minimum diameter of the lamp should not be less than 6 mm.
