LED lighting installation and construction technology standards
Ceiling fluorescent lamp installation:
Determine the position of the fluorescent lamp according to the design drawing, attach the fluorescent lamp to the surface of the building, the lamp box of the fluorescent lamp should completely cover the lamp head box, make a wire inlet hole facing the position of the lamp head box, throw the power cord into the lamp box, Plastic tubes should be covered to protect the wires. Find the position of the screw hole of the light box, drill the hole with an electric drill on the bottom plate of the light box, tighten it with a machine screw, and use the expansion bolt to fix it at the other end of the light box. If the fluorescent lamp is installed on the ceiling, the light box should be fixed to the keel with self-tapping screws. After the light box is fixed, press the power cord into the terminal board (porcelain connector) in the light box. Fix the reflector of the lamp on the light box, adjust the light box to be straight, and finally install the fluorescent tube.
Hanging chain fluorescent lamp installation:
According to the installation height of the lamps, weave all the hanging chains, hang the hanging chains on the hooks of the light box, and install a plastic (wood) table on the ceiling of the building, fork the wires in the hanging chains in sequence, and introduce them into the light box , A soft plastic tube should be covered at the inlet hole of the light box to protect the wire, and pressed into the terminal board (porcelain joint) in the light box. Connect the lamp wire to the power cable thrown out of the lamp holder box, and wrap it tightly with adhesive plastic tape and black tape in layers. Straighten out the joint and buckle it in the flange, the center of the flange (hanging box) should be aligned with the center of the plastic (wood) table, and tighten it firmly with wood screws. Fix the reflector of the lamp on the light box with machine screws, adjust the lamp feet, and finally install the lamp tube.
Installation of combined ceiling lanterns:
According to the position of the embedded bolts and the lamp head box, use an electric drill to open the installation holes and outlet holes on the support plate of the lamp. When installing, lift the support plate, connect the power cord and the wire thrown out of the lamp and wrap it tightly. The wires should be inserted into the lamp holder box as much as possible, and then the mounting holes of the support plate should be aligned with the embedded bolts, so that the surrounding of the support plate and the ceiling are tightly attached, tighten them with nuts, adjust each lamp socket, and hang the lamps and lanterns. All kinds of decorations, and good lamps and light bulbs.
Hanging lantern installation:
Hold up the lamp and insert the pre-buried boom into the lamp. After inserting the hanging pin, break the tail into a dovetail shape and flatten it. After the wires are connected to the head, they are tightly wrapped. After straightening, push up the buckle bowl on the upper part of the lamp, buckle the connector in it, and close the buckle bowl to the ceiling, and tighten the fixing screws. Adjust all lights. Put on the light bulb, and finally add the lampshade.
