Radar LED tube installation underground garage wiring method
Radar light tubes have been widely used in underground garages, which are highly efficient and energy-saving. Shenzhen Langte Lighting is a manufacturer of radar light tubes, and the price of radar light tubes is reasonable. The wiring method of the radar lamp is simple and reliable. Radar tubes in underground garages can save a lot of electricity bills.
1. The principle of the wiring method of the underground garage with the Radar LED tube
Since underground garage lighting is long-term and intermittent lighting, inductive LED fluorescent lamps are generally used in underground garages. Radar-sensing LED fluorescent lamps are the first choice, followed by voice-activated sensing LED fluorescent lamps, and human body-sensing LED fluorescent lamps.
2. Features
1. The sensing distance is farther, the angle is wide, and there is no dead zone.
2. It can penetrate glass and thin wood, and is not affected by environment, temperature, dust, etc.
3. In the case of 37 degrees, the sensing distance will not be shortened.
4. The reaction speed is fast, and the radar switch is an ideal replacement product for the infrared switch.
Third, the price of radar tubes
The price of the radar tube is about 29 yuan. The radar sensor switch, also known as the microwave sensor switch, is based on the Doppler effect. The price of the radar tube adopts the most advanced planar antenna, which can effectively suppress high-order harmonics and other clutter. Interference, high sensitivity, strong reliability, safety and convenience, intelligent energy saving, and lower price of radar lamps are the first choice products for building intelligence and property management modernization. Low power consumption, complete functions, can be equipped with all kinds of lamps.
Four, radar lamp manual
The LED radar sensor tube is not only smart but also very energy-saving. It is mostly used in underground garages and other public places that need to be turned on for 24 hours. The installation of the radar tube manual is simple and convenient. Just install it directly on the bracket like the T8 split elliptical tube. , The old bracket needs to be removed if the starter or rectifier is removed
Five, LED radar tube installation method
1. The difference between the installation method of the radar tube and the conventional tube is that the inductive ballast, electronic ballast and starter connected to the bracket must be removed before installing the LED tube. Otherwise, the LED tube will be burnt out. Remove the ballast and starter, press the socket of the lamp holder into the holder of the lamp holder, and then rotate 90° to fix it
2. The wiring method of the Radar LED tube and the installation method of the Radar LED tube. The line is composed of a live wire (L), a neutral wire (N), a ballast, a lamp tube, and a starter. The two sides of the Radar LED tube are respectively connected to the neutral wire and the live wire , The ballast is connected to the live wire connected to the lamp tube to adjust the current through the lamp tube. When connected, it is connected from the N pole of the ballast, and then connected from the L pole and connected to the switch. The starter is connected to the lamp tube , Used to preheat the filament of the fluorescent lamp. The whole wiring process needs to pay attention to that the live wire must pass through the switch and ballast.
Radar lamp wiring diagram, radar lamp wiring method
6. Matters needing attention for radar lamp
The radar tube looks directly at the light-emitting surface of the LED for a long time, and do not use the reflected LED light to illuminate the eyes of others. Keep away from open flames or high-temperature objects that have exceeded the expiration date, and need to be repaired and inspected or scrapped.
Radar lamp maintenance items:
1. Before cleaning the lamp, be sure to turn off the power.
2. Please use a dry or relatively dry cloth for cleaning.
3. Do not use chemical or corrosive things to clean.
