What are the common problems of landscape lights
1. The quality of construction is poor, and the proportion of faults is relatively large. The object of landscape lighting custom lighting is different from indoor lighting and architectural environment lighting. Its main purpose is to enhance the effect of scenery and create a night landscape. Therefore, in terms of light source types, light sources with better direction and control capabilities should be selected as far as possible, and ordinary floodlighting lamps should be reduced. The main manifestations are: first, the cable trench is not deep enough, and the sand-coated bricks are not constructed according to the standard; second, the production and installation of the aisle pipe do not meet the requirements, and the two ends are not made according to the standard. Drag to the ground; fourth, the foundation buried pipe is not constructed in accordance with the standard requirements, the main reason is that the buried pipe is too thin, plus certain bends, it is difficult to use the cable, and there is a dead corner at the bottom of the foundation. Fifth, the thread pressure and the thickness of the insulation package are not enough, and the phases will be short-circuited after a long period of time.
2. Material failure. Due to the failures dealt with in recent years, the material quality is also low due to many factors. Its main properties are: the wire contains less aluminum, the wire is hard, and the insulation layer is thin. In recent years, this situation has become more common.
3. The quality of supporting works is not good, and cables for landscape lights are generally laid on the green belt. The construction quality of the pavement is poor, and the ground collapses, causing the cableway to deform and cause cable armor. Especially the northeast region is located in the high-cold area, the winter comes, so that the cable and the soil form a whole, once the ground subsides, it will be pulled to the bottom of the landscape lamp foundation, and in summer, rainwater will burn at the root of the foundation.
4. The design is unreasonable, on the one hand it is overload operation. The lighting requirements of different positions in the customization of landscape lights are quite different. In order to show the beautiful shapes of the buildings, sculptures, flowers, trees, mountains and rocks in the garden, the lighting method should be different according to the scene, and the projection light should also be based on the needs. Change the strength and weakness in order to show their respective charm at night; the street lights on both sides of the park road should have uniform and continuous illumination to meet the needs of safety. With the continuous development of urban construction, landscape lights are also expanding. When a new landscape light is built, it is usually close to the landscape light and connected to which loop. In addition, in recent years, the advertising industry has developed rapidly, and the advertising load is connected with the landscape lights, which makes the load of the landscape lights excessive. Cable overheating, wire end overheating, insulation reduction, grounding short circuit, etc.; on the other hand, when designing a light pole, only its own situation is considered, and the space of the cable head is ignored. After the cable head is wrapped, most of the doors do not close. Sometimes the cable is not long enough and the joints do not meet the requirements. This is also the reason for the failure.
